Installation Tips for the Bathroom Towel Holder

Bathroom towel holders are common hardware accessories in our daily life, making it more convenient to take a bath. However, the installation location of bathroom towel holders is also very important. In order to make it more user-friendly, we need to understand the installation location and installation requirements of bathroom shelf and towel holder, so that we can easily install them on our own.

Installation location of bathroom towel holders

• There are many different types of bathroom towel holders, and the height of the towel rack after installation will also vary depending on the specific type. Therefore, we recommend that you install the bathroom towel holder in the middle of the bathroom or on a relatively spacious wall. Generally, the bathroom towel holder is installed at a height of about 1.8 meters above the floor, with bath towels placed on the top and towels hung underneath. For double-pipe bathroom towel holders, they should be installed on a spacious wall in the bathroom. When installing a single-pipe bathroom towel holder, it should be installed about 1.6 meters above the floor. If it is installed alone, then the height should be about 1.5 meters above the floor.

• In fact, the installation height of towel rack and shelf depends on the individual, so it is better to install them in the most convenient place for us to reach. Generally, if there is a bathtub, the bathroom towel holder can be installed above it. The height of the bathroom towel holder without a bathtub is usually between 0.9 meters and 1.4 meters above the ground. It can be installed opposite or next to the showerhead.
  

• Generally, the installation of bathroom towel holders follows a standard size, but in interior design and decoration, we need to pay more attention to humanization. Therefore, we can install the bathroom towel holder according to our actual needs. Before installation, we should check the quality of the bathroom towel holder. First, tightly grip one end of the hanging rod of the towel rack with one hand, and then rub it from one end to the other with the other hand. If the quality is poor, you will touch small burrs or even paint chips that have peeled off.
  

Installation requirements of bathroom towel holders

• Before installation, we can grip one end of the hanging rod of the bathroom towel holder with one hand, and then rub it from one end to the other with the other hand, which can help us detect small burrs or peeling paint that are hard to spot with the naked eye. We should also pay attention to the quality of the electroplating and coating of each bracket. At an angle of about 70 degrees from the viewing angle and incident light, we can easily observe whether there are defects.

• We can use plastic expansion pipes and copper screws to install the bathroom towel holder. This method has small tile damage, is easy to operate, and does not rust, making it easy to maintain.
  

• During installation, we can use an electric drill to drill holes in the wall, insert the expansion screws, and then tighten the screws with a screwdriver. In addition, on the fixed points of the bottom of the bracket, there are generally supporting screws, which cannot be stripped or damaged, otherwise it will be difficult to fix. This can be tested with a small screwdriver when purchasing. Tools required for bathroom towel holder installation: pen, ruler, expansion screws, electric drill, drill bit, etc.