Bathroom is one of the most important places in our home. So, bathroom supplies are also very important, and nowadays, almost every consumer family uses a shower head while taking a bath. By using a shower head, people can better use the amount of hot water provided by the water heater according to their needs. The function of the bathroom shower head set is to clean the dirt from the human body. However, with the continuous advancement of scientific technology and people's yearning for a high-quality life, the function of the shower head is becoming stronger and stronger. So, do you know how to clean the shower head after long-term use? Let's take a look at the cleaning methods of the shower head together. We have bath handheld shower heads and wall mounted rain shower head.
If some of the small holes of your shower head are blocked, then first turn on the water and see which holes are blocked. Then, you need to open the shower head and see that there are many small holes on the shower head, just like a lotus head. This is where the water comes out. Then, prepare a needle, and use the needle to puncture the impurities in the blocked holes until there are no impurities inside the holes. This method is the most direct, but be careful not to puncture the shower holes.
This is commonly used in households. After removing the shower head, soak it in a small bowl of vinegar for about two hours, then use a toothbrush to scrub it and rinse it with clean water; if there are hard water deposits, use a lemon slice to scrub. However, when cleaning the shower head (lotus head), be especially careful not to use strong acid to avoid corrosion of the surface. In order to ensure that the head does not clog, it is best to clean the shower head every six months or shorter, so that you do not have to worry about the shower head being blocked suddenly during bathing, which affects your mood.
However, if the lotus head in your home is severely clogged due to metal rust, then you need to use WD-40 rust remover and lubricant. This rust remover and lubricant can have a very good affinity and permeability with metal. It can separate the rust layer from the metal layer. Make the rusted part and the contact surface of the metal, and leave a protective film, so that the shower head will never rust again.